Pellet Stove Furnace
Pellet stoves can be purchased as freestanding units or fireplace inserts that give your home the appearance of an old-fashioned fireplace that burns wood. These stoves are available in freestanding models as well as fireplace inserts. They can give the appearance of a traditional wood-burning fire.
The auger moves the pellets out of the hopper into the combustion chamber, where they are burnt and generate heat. Sensors detect the flame and adjust the rate of operation to maintain the desired temperature of the room.
1. Energy Efficiency
Pellet stoves burn a renewable, non-toxic fuel made of compressed sawdust wood chips, bark, and other materials that are normally placed in landfills but which can be repurposed into an efficient and clean source of heating. They help homeowners reduce their energy usage, and thus greenhouse gas emissions. Many users of pellet stoves say that they have recouped their initial investment in few years through a reduction in their heating bills.
Pellets are more dense and compressed than natural wood, which makes them more efficient in burning. They also produce much less creosote buildup than traditional fireplaces that burn wood. Additionally, they are packed in plastic bags that seal out moisture and need less frequent cleaning.
Pellet stoves, as with other heating systems, need to be sized and vented properly. A skilled technician can assess your venting requirements and space to ensure the most efficient results.
During installation, the hearth is built to size and the vent is installed through a pre-cut hole in your home's siding. The vent may be installed through a roof or sidewall depending on your preference and the local laws.
After the hearth and vent are done, the pellet stove may be connected. Some manufacturers provide an electronic remote control that makes it simple to start and maintain the fire, while other manufacturers offer additional sensors that monitor airflow and combustion, flue temperatures, and pressure. When the system detects it requires more pellets or less, it sends a signal to the auger to speed up or slow it down accordingly.
All stoves come with a container that can hold between 35 and 130 pounds of pellets. pellet stove furnace determine the frequency at which the stove will need to be filled, with larger hoppers allowing longer intervals between refills. A grille pulls fresh air from the room and passes it over an exchanger that then blows heated air into the living space by convection. pellet stove furnace , auger or other device distributes pellets and a pan below will collect any pellets that are not burned as well as the combustion residue.
Pellet stoves are less energy-intensive than wood-burning models, but aren't as efficient as electric heaters or natural gas furnaces. The electric components that drive their motorized parts require electricity, which could be an issue during a power failure, but backup systems are in place, such as generators and batteries.
2. Low Maintenance
Pellet stoves are incredibly efficient, but like all major heating appliances, they require some maintenance to keep them running correctly. Cleaning your stove and its exhaust vent regularly will prevent the buildup of harmful creosote. This could cause a fire or explosion that could damage the stove and/or your home.
A pellet stove makes use of natural particles that are compressed (such as kernels, nutshells of corn, or small pieces of scrapwood) made from wood or other substances. An electric-powered auger is used to feed the fuel pellets from a hopper into the burner and into the combustion chamber. The thermostat you set controls the rate at which pellets are fed to the burner. The fire can be kept roaring or decreased or even extinguished in accordance with the temperature you set. When the fire goes out, the ash is dropped into an empty ash tray beneath the burner, which can be easily removed and then disposed of.
Pellets are made from byproducts that would have been thrown away when processing lumber. They are a sustainable source and produce less particulates than traditional wood-burning appliances making pellet stoves a cleaner heat source. The amount of carbon monoxide, carcinogens, and other harmful chemicals emitted by pellet stoves is much lower than those with modern EPA-certified wood stoves.
Due to the low emission the stoves are not required to be vented through chimneys like traditional wood stoves, but should be properly vented through a wall or another external structure. Pellet stoves have flue ports on the front or back of the appliance. They are connected to a ventpipe that extends outside the home.
One disadvantage of a pellet stove is that you must purchase or store enough pellets to last through the winter season. On average, owners of pellet stoves consume three tons of pellets during the course of winter at $200 per ton. The costs can increase over time however, it's cheaper than buying and hauling firewood for an old-fashioned wood-burning fireplace or stove. You should buy enough pellets to ensure your stove can run through the winter's coldest months. Also, you require a location to store the pellets (preferably cool and dry).
3. Reduced Carbon Footprint
Pellet stoves use renewable biomass fuel to create heat, thus reducing the dependence on finite fossil fuels. This helps reduce the carbon footprint as well as helping diversify the sources of energy used in homes.
Even the most modern woodstoves that are EPA certified emit significantly less than pellet stoves. The emissions from pellet stoves are considerably lower than ones from gas furnaces. Pellets are made from compressed sawdust, bark and other lumber leftovers and may also contain a variety of other materials like soybeans, corn, nutshells, cherry pits and agricultural waste. When they are burned, they emit less particulates, which could cause respiratory issues and allergies and carcinogens as well as nitrous dioxide.
The main difference between a wood stove and a pellet stove is the feed system. Pellet stoves are equipped with hoppers to store the pellets. When the thermostat or sensors signal that the room requires heating, the auger is turned and the pellets are pumped into the combustion chamber where they are burned and generate heat. The combustion chamber flows through a heat exchanger that transmits the heat to the blower and out into the room. This process results in very low emissions and no creosote buildup.
After the hopper is empty, a cyclone process takes away the ash and puts it in an ash pan. The stove is equipped with an air-flow system that circulates the heated, clean air into the room. Most pellet stoves require minimal maintenance and feature a large viewing area for you and your family to enjoy the flames.
The quality of pellets is the most important factor that affects the emissions from pellet stoves. Poor-quality pellets will produce more emissions. When choosing your pellets, ensure that they meet certain standards and don't contain other ingredients, such as petroleum-based or urea-based products. Look for a company that has a guarantee and will repair or replace parts in the event of a problem. Some states offer homeowners a tax credit if they want to go even greener. This is a great opportunity to reduce the initial cost of this kind of stove and make it easier to set up.
4. Reduced Noise
Pellet stoves generate very little smoke and emissions as compared to fireplaces that burn wood. They also use an electric fan to distribute heat more evenly throughout the space. This is the reason pellet stoves need less maintenance than wood stoves. While wood stoves require frequent cleaning of chemicals and particulates to prevent deterioration, pellet stoves can be cleaned by a metal vacuum cleaner.
Many manufacturers have designed their stoves to ensure that they are simple to install, operate and maintain. They also offer their stoves in a variety of styles to match the decor of your home. Some come with programmable thermostats, remote control and WIFI app so you can monitor and manage your stove from any location in the world.
Most pellet stoves come with an enormous fuel hopper which can accommodate between 35 and 130 pounds of pellets. The pellets are then pumped into the combustion chamber via an auger. The output of heat and how hot the fire gets depends on the speed at which the pellets are fed into the burner. The hopper can either be filled with hardwood pellets made from dense wood species like hickory and oak or softwood pellets. Many stoves can use biomass pellets made of corn and switchgrass. This is a green alternative.
Since pellet stoves burn as a clean fuel, they emit less smoke than conventional wood-burning fireplaces and require fewer maintenance. They also don't require a chimney, which makes them a much more suitable choice for new construction or retrofits.
In contrast to wood stoves, which need to be kept regularly free of creosote and other chemicals, pellet stoves require periodic inspections to ensure proper operation and maintenance. Depending on the model, this could include a regular inspection and cleaning of the accumulation of the ash or "clinker," as well as the motor and fan. Your appliance dealer will be able to provide the proper procedures for your brand and model. He can also help you identify the right fuel for your stove and provide information regarding storage and safety.